This oil/fuel pressure sensor will allow an aftermarket engine management system to monitor oil pressure and take immediate action if a fault condition is encountered.
Using a G4+ or G4X ECU we simply setup a Table dedicated to the Oil or Fuel pressure based on engine speed and Map load to safely implement a rev limit should the pressure fall under a desired level.
This oil pressure sensor uses a 1/8″ NPT thread and a GT150 3-pin connector. The plug housing and terminals are included. Most aftermarket ECUs allow the sensor calibration data to be entered via the tuning software. The linear calibration for this particular sensor is:
0.5V = 0 kpa
4.5V = 689.476 kpa