Cherry GS100701 Hall effect gear tooth speed sensor supplied with a DTM connector. For ferrous target detection in camshaft, crankshaft and wheel-speed sensing applications.
Included
- Cherry GS100701 Hall effect sensor
- DTM connector
Installation
A pull-up resistor is required. Confirm your ECU input configuration and target arrangement before installation. Contact sales@ae-race.com for wiring and installation enquiries.
DTM connector pinout
- Pin 1: Sensor ground
- Pin 2: Signal
- Pin 3: Sensor supply
Specifications
- Hall effect sensing with sinking-current output
- Sensing capability: near zero speed to 15 kHz
- Operating supply: 5–24 VDC
- Maximum input voltage: 30 VDC
- Maximum reverse voltage: 24 VDC
- Supply current: 3 mA typical, 6 mA maximum
- Output sink current: 20 mA maximum
- Operating temperature: -40 to 125°C
- IP67 protection rating
- Anodized aluminum housing
- Thread: 15/32"-32
- Cable: 20 AWG × 1 m
Recommended external pull-up resistor
- 5 VDC: 1 kΩ
- 9 VDC: 1.8 kΩ
- 12 VDC: 2.4 kΩ
- 15 VDC: 3 kΩ
- 24 VDC: 3 kΩ
Optional bolt-on wheel-speed kits for selected vehicles may be available; enquire about availability.